Skip to content
brep-conformancegithub

fillet_setback

Blends · api.md § fillet_setback · all operations

fillet_setback(s: Solid, edges: list<Point3>, radius: Length, setback: Length) -> Solid

Rounds edges as fillet of radius does, except at every corner where three named edges meet. There, each fillet stops setback short of the corner, and one smooth patch closes the corner. The patch meets the three fillets and the three faces tangentially. setback must be greater than radius. Farther than setback from such a corner, each edge is as fillet makes it.

The patch is open within limits. The result lies, point for point, between two solids: s filleted with the corner's cube of side setback taken away, and s filleted with the corner left sharp. Neither of those two solids is itself a result, because the patch leaves no crease. On each face, the flat stops short of the point where the contact lines of the face's two fillets would cross. The rolling-ball corner reaches that point. A square corner whose three edges are filleted and set back alike is closed alike on all three edges: the result is unchanged by any swap of the three edges, within a thousandth of the radius.

Example. Solid 1 is a 10 × 20 × 30 mm box with one corner at the origin. The three edges meet at the origin.

> {"cmd": "fillet_setback", "s": 1, "edges": [[5, 0, 0], [0, 10, 0], [0, 0, 15]],
   "radius": 1, "setback": 2}
< {"ok": 2}

An edge is named by a point on it. Each point names the edge of s that passes within 10·ε of the point, where ε is the suite's tolerance of 1e-7 mm. A call with a point that names no edge refuses. Naming an edge by a point does not depend on how any kernel numbers or labels its topology, and a test can compute such a point from the solid's definition.

A blend runs along the whole tangent chain of its edge. The chain is the named edge and every edge reached from it through vertices where the next edge leaves in the direction in which the last edge arrived. The top loop of a prism on a rounded rectangle is one chain, so a point on any edge of that loop blends the whole loop. Following the chain is the work of the function, and so of the kernel. An adapter passes on the edge the point names and no other edge.

FunctionFieldsReturns
fillets, edges, radiusSolid
fillet_radiis, edges, radiiSolid
fillet_variables, edge, from, r_from, r_toSolid
fillet_conics, edges, setback, rhoSolid
fillet_g2s, edges, offset, centerSolid
fillet_setbacks, edges, radius, setbackSolid
fillet_setback_g2s, edges, radius, setbackSolid
fillet_facess, face_a, face_b, radiusSolid
full_rounds, side_a, middle, side_bSolid
chamfers, edges, distanceSolid
chamfer_twos, edge, face, d1, d2Solid
chamfer_distancess, edges, distancesSolid